The process..... ⚠️Attention! You can only get these results if you prep the substrate properly for tile. Follow and understand TCNA handbook manual and you will succeed every time. Here are the steps @codeman_00@kriv4o and I had to take on this job and the details. Existing tile over concrete floor. The existing tile was tenting around the perimeter of the rooms due to failure to provide movement joints every 16’-20’ in each direction. We did : - Remove old tile. - install bekotec edge strip on the walls to provide perimeter movement joint. @schlutersystemsna - Prime and Self level the floor with ARDEX K10 @ardexamericas to achieve flat floor with no more then 1/8” variation in 10’ - Install Ditra Heat TB. Sound control was required by the building association. @schlutersystemsna -install Dilex BWB every 16’-20’ on each direction. Dilex BWB is a surface joint profile with rigid PVC anchoring legs that protect tile edges and a 3/8" (10 mm)-wide, soft CPE movement zone that separates individual fields in the tile covering. @schlutersystemsna
The Bosch GLL3-330CG green line laser is are go to. For any kind of layout. From tile to framing. We are using it to line up the post and knee wall with the beam at #projectrobroy
@FastenMaster ThruLok Demi & review - do it faster, do it stronger 💪 #Repost@fastenmasterpro with @download_repost ・・・ From @merrill.tn: "These things are pretty cool and save a bunch of time and we all know time = $" How much more money could you make if you're saving 30 seconds per fastener over a deck project? Over 10 deck projects?