Instagram post by @prototype__prodigy Trevor Goforth

This one was a little tricky, it’s kind of tough to see in the picture but there is a slot that goes through the part and also through the end of the part which made clamping the part in the vise a little difficult. The tolerance on the width of the slot was +.001/-.000 needless to say I had to rough machine the slot first then allow it to spring open or collapse shut. Then I squared the outside of the part up again and continued from there.. the part is 11.5 inches long so holding the tolerance on the width of the slot over roughly 9 inches was not fun..

8 Comments

Most Popular Instagram Hashtags