pr0jekt P O K E 9h

» LOG IN to write comment.

pr0jekt Tire wouldn't hold air. It was leaking from the inside of the bead. Anyone have this issue? Put bead sealer on there and so far it's good. Max psi on the tire is 49 and it was leaking after 30 psi. Tire is 215/35/19 on a 19x9.5. 1d
  •   mcdaniel_209 Check the wheel for any cracks on the inner brim. Happened to me, damn potholes haha 1d
  •   cj_solow @alexandermjoyce yea I did the same as @looneylow 195 45 toyo on a 15x10 showing 1/4" of barrel on each side and ran 79psi. Hell I had it up to 120psi to seat. @pr0jekt could be the tire brand. Some stretch better than others or could just need to be cleaned and tried again. 1d
  •   initials_r_jdm I never run A symmetrical when fitting a narrow tire on a wide rim. Directional only. Plus I clean the bean on the wheel really good and use hair spray to seat the bean. And also run about 40-45psi. I have 255/35 on a 11.5 18" and no problems @pr0jekt 1d
  •   pr0jekt @initials_r_jdm Perhaps on my next day off I can bring it to you to take a look 1d
  •   styleup_strat I bet the tire is just faulty dude 1d
  •   styleup_strat The stress that was on it from the stretch 1d
  •   squattinjzs160 My Amistad does that too. Turns out to be the seal on the valve stem. Checked your sealant between the barrels too. Might have been taken apart before and not sealed well. 1d
  •   sxe10atl Tires are too small dude. Go to a 225 23h

» LOG IN to write comment.

» LOG IN to write comment.

pr0jekt • P R O G R E S S • 3d

» LOG IN to write comment.

pr0jekt 9.64 Sec GTR | That Lexus Tho 1w
  •   asvpxpmf Slow 1w
  •   frankiefohdoh I'd take that Lexus over the GTR any day 1w
  •   shaun_cj Orr you'd get the GTR and sell it then you could have as many as you wanted????? 7d

» LOG IN to write comment.

pr0jekt Really needing that camber to get the fitment I want. Also think this winter I'll be going with a kit. 1w

» LOG IN to write comment.

» LOG IN to write comment.

pr0jekt I cannot give you the formula for success, but I can give you the formula for failure--which is: Try to please everybody. 2w

» LOG IN to write comment.

» LOG IN to write comment.

» LOG IN to write comment.

» LOG IN to write comment.

pr0jekt Well... It was a long night last night trying to make these 19x9 +6/+15 wheels fit the car. Really need to camber all four sides then it will look good. Now I'm waiting to hear back from @figsengineering to see what all I need and price. 2w

» LOG IN to write comment.

» LOG IN to write comment.

» LOG IN to write comment.

» LOG IN to write comment.

» LOG IN to write comment.

pr0jekt < L A S T • O N E > 4w

» LOG IN to write comment.

» LOG IN to write comment.

pr0jekt We've got some work to do to get these to fit perfectly. We are up for the challenge though. 4w

» LOG IN to write comment.

pr0jekt You only live once, but if you do it right, once is enough. 4w

» LOG IN to write comment.